Linux version 2.6.39.4 (buildslave@dd.das-iro.de) (gcc version 4.5.4 20110808 (prerelease) (Linaro GCC 4.5-2011.08) ) #1 Thu Oct 27 04:56:37 CEST 2011 prom: fw_arg0=00000008, fw_arg1=a1f87fb0, fw_arg2=a1f88470, fw_arg3=00000004 MyLoader: sysp=f0f0f0f0, boardp=f0f0f0f0, parts=f0f0f0f0 bootconsole [early0] enabled CPU revision is: 00019374 (MIPS 24Kc) SoC: Atheros AR7241 rev 1 Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:5.000MHz Determined physical RAM map: memory: 02000000 @ 00000000 (usable) Initrd not found or empty - disabling initrd Zone PFN ranges: Normal 0x00000000 -> 0x00002000 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00000000 -> 0x00002000 On node 0 totalpages: 8192 free_area_init_node: node 0, pgdat 802d1510, node_mem_map 81000000 Normal zone: 64 pages used for memmap Normal zone: 0 pages reserved Normal zone: 8128 pages, LIFO batch:0 pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768 pcpu-alloc: [0] 0 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 Kernel command line: board=TL-MR3220 console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd PID hash table entries: 128 (order: -3, 512 bytes) Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes Writing ErrCtl register=00000000 Readback ErrCtl register=00000000 Memory: 29268k/32768k available (2102k kernel code, 3500k reserved, 400k data, 180k init, 0k highmem) SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 NR_IRQS:80 Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 NET: Registered protocol family 16 MIPS: machine is TP-LINK TL-MR3220 registering PCI controller with io_map_base unset bio: create slab at 0 pci 0000:00:00.0: [168c:ff1c] type 0 class 0x000200 pci 0000:00:00.0: fixup device configuration pci 0000:00:00.0: reg 10: [mem 0x00000000-0x0000ffff 64bit] pci 0000:00:00.0: supports D1 pci 0000:00:00.0: PME# supported from D0 D1 D3hot pci 0000:00:00.0: PME# disabled pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x1000ffff 64bit] pci 0000:00:00.0: BAR 0: set to [mem 0x10000000-0x1000ffff 64bit] (PCI address [0x10000000-0x1000ffff]) PCI: mapping irq 72 to pin1@0000:00:00.0 Switching to clocksource MIPS NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 PCI: CLS 0 bytes, default 32 squashfs: version 4.0 (2009/01/31) Phillip Lougher JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. msgmni has been set to 57 io scheduler noop registered io scheduler deadline registered (default) Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A console [ttyS0] enabled, bootconsole disabled Atheros AR71xx SPI Controller driver version 0.2.4 m25p80 spi0.0: found en25f32, expected m25p80 m25p80 spi0.0: en25f32 (4096 Kbytes) spi0.0: searching for MyLoader partition table at offset 0x10000 spi0.0: searching for MyLoader partition table at offset 0x20000 spi0.0: searching for MyLoader partition table at offset 0x30000 spi0.0: searching for MyLoader partition table at offset 0x40000 spi0.0: no MyLoader partition table found Searching for RedBoot partition table in spi0.0 at offset 0x3fe000 Searching for RedBoot partition table in spi0.0 at offset 0x3ff000 No RedBoot partition table detected in spi0.0 spi0.0: no WRT160NL signature found Creating 5 MTD partitions on "spi0.0": 0x000000000000-0x000000020000 : "u-boot" 0x000000020000-0x000000160000 : "kernel" 0x000000160000-0x0000003f0000 : "rootfs" mtd: partition "rootfs" set to be root filesystem mtd: partition "rootfs_data" created automatically, ofs=2CA000, len=126000 0x0000002ca000-0x0000003f0000 : "rootfs_data" 0x0000003f0000-0x000000400000 : "art" 0x000000020000-0x0000003f0000 : "firmware" ag71xx_mdio: probed eth0: Atheros AG71xx at 0xba000000, irq 5 eth0: Found an AR7240 built-in switch eth1: Atheros AG71xx at 0xb9000000, irq 4 eth1: connected to PHY at ag71xx-mdio:04 [uid=004dd041, driver=Generic PHY] Atheros AR71xx hardware watchdog driver version 0.1.0 ar71xx-wdt: timeout=15 secs (max=21) TCP westwood registered NET: Registered protocol family 17 Bridge firewalling registered 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller VFS: Mounted root (squashfs filesystem) readonly on device 31:2. Freeing unused kernel memory: 180k freed input: gpio-keys-polled as /devices/platform/gpio-keys-polled/input/input0 Button Hotplug driver version 0.4.1 eth0: link up (1000Mbps/Full duplex) Registered led device: tl-mr3x20:green:system Registered led device: tl-mr3x20:green:qss Registered led device: tl-mr3x20:green:3g JFFS2 notice: (376) jffs2_build_xattr_subsystem: complete building xattr subsystem, 1 of xdatum (1 unchecked, 0 orphan) and 16 of xref (0 dead, 2 orphan) found. eth0: link down eth0: link up (1000Mbps/Full duplex) device eth0 entered promiscuous mode br-lan: port 1(eth0) entering forwarding state br-lan: port 1(eth0) entering forwarding state Compat-wireless backport release: compat-wireless-2011-09-28-6-g8163a60 Backport based on wireless-testing.git master-2011-10-05 cfg80211: Calling CRDA to update world regulatory domain usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb cfg80211: World regulatory domain updated: cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) PCI: Setting latency timer of device 0000:00:00.0 to 64 ath: EEPROM regdomain: 0x0 ath: EEPROM indicates default country code should be used ath: doing EEPROM country->regdmn map search ath: country maps to regdmn code: 0x3a ath: Country alpha2 being used: US ath: Regpair used: 0x3a ieee80211 phy0: Selected rate control algorithm 'minstrel_ht' Registered led device: ath9k-phy0 ieee80211 phy0: Atheros AR9285 Rev:2 mem=0xb0000000, irq=72 cfg80211: Calling CRDA for country: US PPP generic driver version 2.4.2 ip_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 24 cfg80211: Regulatory domain changed to country: US cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm) cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm) cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm) ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver ar71xx-ehci ar71xx-ehci: Atheros AR91xx built-in EHCI controller ar71xx-ehci ar71xx-ehci: new USB bus registered, assigned bus number 1 ar71xx-ehci ar71xx-ehci: irq 3, io mem 0x1b000000 ar71xx-ehci ar71xx-ehci: USB 2.0 started, EHCI 1.00 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected nf_conntrack version 0.5.0 (460 buckets, 1840 max) ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver ar71xx-wdt: enabling watchdog timer eth1: link up (100Mbps/Full duplex)