@ U-Boot 1.1.4 (Jan 25 2011 - 12:09:11) AP99 (ar7241 - Virian) U-boot DRAM: sri ar7240_ddr_initial_config(133): virian ddr1 init #### TAP VALUE 1 = 0xf, 2 = 0x10 [0x0: 0x1f] 32 MB id read 0x100000ff sector count = 64 Flash: 4 MB Using default environment In: serial Out: serial Err: serial Net: ag7240_enet_initialize... No valid address in Flash. Using fixed address No valid address in Flash. Using fixed address Virian MDC CFG Value ==> 4 : cfg1 0xf cfg2 0x7014 eth0: 00:03:7f:09:0b:ad eth0 up Virian MDC CFG Value ==> 4 : cfg1 0xf cfg2 0x7214 eth1: 00:03:7f:09:0b:ad ATHRS26: resetting s26 ATHRS26: s26 reset done eth1 up eth0, eth1 Autobooting in 1 seconds ## Booting image at 9f020000 ... Uncompressing Kernel Image ... OK Starting kernel ... Linux version 2.6.39.4 (fubar@ee.hrach.eu) (gcc version 4.5.4 20110808 (prerelease) (Linaro GCC 4.51 bootconsole [early0] enabled CPU revision is: 00019374 (MIPS 24Kc) SoC: Atheros AR7241 rev 1 Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:5.000MHz Determined physical RAM map: memory: 02000000 @ 00000000 (usable) Initrd not found or empty - disabling initrd Zone PFN ranges: Normal 0x00000000 -> 0x00002000 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0x00000000 -> 0x00002000 Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 Kernel command line: board=TL-MR3220 console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd PID hash table entries: 128 (order: -3, 512 bytes) Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes Writing ErrCtl register=00000000 Readback ErrCtl register=00000000 Memory: 29328k/32768k available (2046k kernel code, 3440k reserved, 396k data, 180k init, 0k highme) SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 NR_IRQS:80 Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 NET: Registered protocol family 16 MIPS: machine is TP-LINK TL-MR3220 registering PCI controller with io_map_base unset bio: create slab at 0 pci 0000:00:00.0: fixup device configuration pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x1000ffff 64bit] pci 0000:00:00.0: BAR 0: set to [mem 0x10000000-0x1000ffff 64bit] (PCI address [0x10000000-0x1000ff) PCI: mapping irq 72 to pin1@0000:00:00.0 Switching to clocksource MIPS NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered UDP hash table entries: 256 (order: 0, 4096 bytes) UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) NET: Registered protocol family 1 squashfs: version 4.0 (2009/01/31) Phillip Lougher JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. msgmni has been set to 57 io scheduler noop registered io scheduler deadline registered (default) Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A console [ttyS0] enabled, bootconsole disabled console [ttyS0] enabled, bootconsole disabled Atheros AR71xx SPI Controller driver version 0.2.4 m25p80 spi0.0: found en25f32, expected m25p80 m25p80 spi0.0: en25f32 (4096 Kbytes) Searching for RedBoot partition table in spi0.0 at offset 0x3fe000 Searching for RedBoot partition table in spi0.0 at offset 0x3ff000 No RedBoot partition table detected in spi0.0 spi0.0: no WRT160NL signature found Creating 5 MTD partitions on "spi0.0": 0x000000000000-0x000000020000 : "u-boot" 0x000000020000-0x000000160000 : "kernel" 0x000000160000-0x0000003f0000 : "rootfs" mtd: partition "rootfs" set to be root filesystem mtd: partition "rootfs_data" created automatically, ofs=2C7000, len=129000 0x0000002c7000-0x0000003f0000 : "rootfs_data" 0x0000003f0000-0x000000400000 : "art" 0x000000020000-0x0000003f0000 : "firmware" ag71xx_mdio: probed eth0: Atheros AG71xx at 0xba000000, irq 5 eth0: Found an AR7240 built-in switch eth1: Atheros AG71xx at 0xb9000000, irq 4 Atheros AR71xx hardware watchdog driver version 0.1.0 TCP westwood registered NET: Registered protocol family 17 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller VFS: Mounted root (squashfs filesystem) readonly on device 31:2. Freeing unused kernel memory: 180k freed input: gpio-keys-polled as /devices/platform/gpio-keys-polled/input/input0 Button Hotplug driver version 0.4.1 - preinit - Press the [f] key and hit [enter] to enter failsafe mode - regular preinit - JFFS2 notice: (376) jffs2_build_xattr_subsystem: complete building xattr subsystem, 1 of xdatum (1 . switching to jffs2 - init - Please press Enter to activate this console. device eth0 entered promiscuous mode Compat-wireless backport release: compat-wireless-2011-09-28-6-g8163a60 Backport based on wireless-testing.git master-2011-10-05 cfg80211: Calling CRDA to update world regulatory domain SCSI subsystem initialized eth1: link up (100Mbps/Full duplex) usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub cfg80211: World regulatory domain updated: cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) usbcore: registered new device driver usb ieee80211 phy0: Atheros AR9285 Rev:2 mem=0xb0000000, irq=72 cfg80211: Calling CRDA for country: US cfg80211: Regulatory domain changed to country: US cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm) cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm) cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm) PPP generic driver version 2.4.2 ip_tables: (C) 2000-2006 Netfilter Core Team NET: Registered protocol family 24 ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver ar71xx-ehci ar71xx-ehci: Atheros AR91xx built-in EHCI controller ar71xx-ehci ar71xx-ehci: new USB bus registered, assigned bus number 1 ar71xx-ehci ar71xx-ehci: irq 3, io mem 0x1b000000 ar71xx-ehci ar71xx-ehci: USB 2.0 started, EHCI 1.00 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected nf_conntrack version 0.5.0 (461 buckets, 1844 max) usb 1-1: new high speed USB device number 2 using ar71xx-ehci ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver Initializing USB Mass Storage driver... scsi0 : usb-storage 1-1:1.0 usbcore: registered new interface driver usb-storage USB Mass Storage support registered. scsi 0:0:0:0: Direct-Access Patriot Memory PMAP PQ: 0 ANSI: 4 sd 0:0:0:0: [sda] 15646720 512-byte logical blocks: (8.01 GB/7.46 GiB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Assuming drive cache: write through sda: sda1 sda2 sda3 sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] Attached SCSI removable disk EXT4-fs (sda1): 10 orphan inodes deleted EXT4-fs (sda1): recovery complete EXT4-fs (sda1): mounted filesystem with ordered data mode. Opts: (null) Algorithmics/MIPS FPU Emulator v1.5 udev[903]: starting version 164 device eth0 left promiscuous mode br-lan: port 1(eth0) entering disabled state device eth0 entered promiscuous mode sshd (1446): /proc/1446/oom_adj is deprecated, please use /proc/1446/oom_score_adj instead.